Rotor Riot FPV Flight Controller

Brave F7 V2 FPV Flight Controller with BMI270 Gyro, BMP390 Barometer, Six UARTs and 3-8S LiPo Input

$79.96
$79.96
Skip to product information
Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
  • Rotor Riot FPV Flight Controller
Brave F7 V2 FPV Flight Controller with BMI270 Gyro, BMP390 Barometer, Six UARTs and 3-8S LiPo Input

Brave F7 V2 FPV Flight Controller with BMI270 Gyro, BMP390 Barometer, Six UARTs and 3-8S LiPo Input

$79.96
$79.96

The Brave F7 V2 flight controller combines a BMI270 gyro, BMP390 barometer and six UARTs in a 37×37mm board for FPV builds. Its connectors support a solder-free build, with solder pads in front of each plug for direct wiring. Betaflight 4.5 or newer is required.

Key Features

  • Plug connections for GPS, HD VTX, analog VTX, camera, receiver and ESC.
  • Dual BEC outputs: 10V/2A and 5V/3A.
  • 16Mb blackbox memory and AT7456 OSD.
  • Peripheral accessories receive power through USB when the board is connected to a computer for setup.

Specifications

  • MCU: STMF722RET6.
  • Gyro: BMI270; barometer: BMP390.
  • Input: 3-8S LiPo.
  • UARTs: 6.
  • Firmware target: RRIOT_F722 (Betaflight).
  • Board dimensions: 37×37mm; mounting holes: 30×30mm.
  • Weight: 8g.

Included Accessories

  • 4 FC vibration dampeners.
  • 1 long FC-to-ESC wiring harness.
  • 1 short FC-to-ESC wiring harness.
  • 1 DJI O3 VTX wiring harness.
  • 1 Avatar HD V2/Moonlight wiring harness.

Setup Note

A high-power VTX such as a Walksnail Avatar may cause Betaflight connection issues during USB setup. If this occurs, disconnect the VTX or connect a battery while the board is connected to the computer.

You may also like